The natural gas detector is specially designed for all household situations. In particular where appliances may be left unattended or there is a risk of gas flames blowing out or being forgotten to be lit. It is mainly used for gas cookers but also can be used to protect fires and other gas appliances (e.g. for Care in the Community).
The Detector (with optional easy-fit valve) provides two key functions:
A remote sensor can be connected to the detector to increase the coverage of the unit. The detector can also trigger remote alarms so that remote monitoring stations can be made aware of the gas detector triggering.
Active protection of the gas appliance is simple with a gas valve (Optional not included with this product). This valve has standard bayonet fittings which enable easy inline connection to existing appliances.
Application
Natural
gas is usually very safe in that it is not poisonous. The main danger
comes from a build up of escaping gas that can eventually reach
explosive levels. These dangerous levels can build up through mistakes
such as forgetting to light a gas ring or natural causes like a pilot
light blowing out
This
becomes a bigger problem where there are confused, elderly or infirm
people who may be less aware of what is going on around them. In the
worse case, leaking gas can build up to explosive levels.
Detecting
the gas is the first part of the problem. The second is to shut off the
gas, make sure it is not re-connected until safe to do so, especially
if there are not likely to be competent people around.

Alarm trigger level: Between 5% and 20% of Lower Explosive Limit (LEL)
Stabilisation time after power applied: up to 4 minutes
Response time: within 30 seconds
Audible sounder: 85 dB at 3 m
Outputs: 2 relays (SPCO)- Relay 1 for controller - Relay 2 for remote signalling
Operating temperature: -10°C to +40°C
Size: 110 x 110 x 57 mm (4.3 x 4.3 x 2.2 inch)
Power: 240v ac
Fuse rating: 3A
Double insulated - no earth connection required
Power consumption: 4 w quiescent
Expected Life: 5 years
Controller
Alarm reset: auto reset key switch
Operating temperature: -10°C to +40°C
Size: 150 x 90 x 65 mm (5.9 x 3.5 x 2.6 inch)
Power: 240v ac
Fuse rating: 3A
Double insulated - no earth connection required
Power failure - failsafe mode will switch off valve on mains power failure (option, can be disabled)